PRAGOPRIMER UNIVERZÁL S2035

The product is intended to be used as a primer coating of iron. It is suitable for coatings of metal structures under nitrocellulose and synthetic enamels drying out on air. It is endowed with excellent drying.

BENEFITS

• active anticorrosive pigment
• quick drying
• suitable under nitrocellulose and polyurethane enamels

SURFACE PREPARATION

The surface must be clean, dry, degreased, free of rust and dust, mechanically cleaned. Application on galvanized sheet is possible after 12 months of weathering.

First of all the surface must be degreased by means of suitable agent (e.g. BALTECH P6402 technical benzine, BALTECH P6401 acetone or, if it is possible, warm pressurized water with detergent). For removing of residues of various salts it is necessary then to rinse the surface with clear water. Rough and sticky impurities must be removed manually or mechanically (grinding, scraping). Possible rust may be removed also manually or mechanically (metal brushes, grinding discs). Formerly coated surfaces must be cleaned, degreased and without old non-adhesive paints.

Thinner: BALTECH S6005 for brush or roller, BALTECH C6000 for spraying

Spreading capacity: 12 - 14 m²/l per one layer

WORKFLOW

Properly mix before use, thin, if it is necessary. Apply by bruch, roller or spraying on prepared surface.
The coating of a metal:
1.    1 coat of PRAGOPRIMER UNIVERSAL S2035. It dries at temperature of approximately 20 °C. Drying can be accelerated by heating up to 80 °C. The coat dried on air can be re-sprayed by synthetic or nitrocellulose enamel already after 1 hour, optimal thickness of one layer is 30 - 35 μm.
2.    1 or 2 coats of synthetic enamel INDUSTROL UNIVERZAL S2013, INDUSTROL UNIMAT S2075 or INDUSTROL PROFI U2129.  Optimal thickness of one layer is 30 – 35 μm.

SHADES

0110 grey, 0840 russett

GHS02 - flammable substances GHS07 - irritants GHS08 - substances hazardous to health GHS09 - substances hazardous to the environment

Signal word: Warning

Xylen (směs)