LAZUROL PRAGOMAT C1038

The varnish is intended for matty and hard coats of wood. It contains substances absorbing UV radiation, it means that the coat does not become yellowish and yellowing of wood under the coat is also limited. The varnish is endowed with excellent drying, quick hardening and very good spreading.

BENEFITS

• quick drying
• extra hard coat
• contains UV stabilizer

SURFACE PREPARATION

Before the application, the timber surface shall be clean, dry, well smoothened, with max. 12% humidity and free of resin residues. The timber surface with high content of resins (larch, pine) shall be cleaned of all resin residues, e.g. by washing by BALTECH C6000 nitro-solvent. Quality of wood preparation determines overall look of the wood final finish and affects total lifetime of the coating system.

Thinner: BALTECH C6000

WORKFLOW

Properly mix before use, thin if it is necessary. Apply by spraying or brush.
1.    Wood surface preparation (grinding, potentially staining, bleaching);
2.    One coat (spray) of varnish LAZUROL PRAGOMAT C1038 diluted with BALTECH C6000 solvent   (approximately 30 %);
3.    Sanding with sandpaper no. 240-320;
4.    2-3 coats of varnish LAZUROL PRAGOMAT C1038. Recoating is possible after 24 hours. Optimal thickness of one coat is 20 μm.
Don´t use it for coating exposed to weather conditions.

GHS02 - flammable substances GHS05 - corrosive and caustic substances GHS07 - irritants GHS08 - substances hazardous to health

Signal word: Danger

Xylen (smes), butan-1-ol, n-butyl-acetát, ethanol.