PRODUCT
The water-based varnish uses on hard and soft woods, especially: furniture, wooden panelling, plywood in interior. It is possible to use it as clear coat on acrylic enamels.
SURFACE PREPARATION
The surface has to be cleaned, rid of grease, dust and loose old coats. Excessive resin has to be stripped. Smooth in grain direction and dust off. The surface impregnates by the varnish thinned with water in ratio 1: 1 or impregnating primer: REMAL, BARLET or SOICRAT. Then it smoothes by sandpaper no. 400-600 after drying at least 4 hours.
RECOMMENDED APPLICATION
Mix properly before use. It shouldn´t be thinned. Apply 2-3 coats. When applies on acrylic coat, the surface slightly smoothes and dusts off (without impregnation), apply 1-2 coats. The surface smoothes with sandpaper no. 400-600, when spraying after 4 hours and apply another coat. The temperature needs to be above 10 °C. Apply by brush, roller or spray.
Content of hazardous substances
reakční směs: 5-chlor-2-methylisothiazol-3(2H)-on [číslo ES 247-500-7]
a 2-methylisothiazol-3(2H)-on [číslo ES 220-239-6] (3:1)
| EUH208 | Contains (see dangerous substances). May cause an allergic reaction. |
