HOSTAGRUND 2v1 ZINEX S2820
-
GHS02 - flammable substances 
GHS05 - corrosive and caustic substances 
GHS07 - irritants 
GHS09 - substances hazardous to the environment
ACRYLATE SINGLE COAT FOR FRESH GALVANIZED IRON
More information
Description
The solvent-based acrylic single coat uses for painting on steel, light metal, galvanized steel in exterior and interior. It can be used under acrylic, polyurethane and epoxy topcoats. The coat has proper adhesion to steel, copper, aluminium and galvanized surfaces including fresh one. It dries quickly and the coat is resistant to weather conditions. The paint is slightly thixotropic, it doesn´t run from vertical surfaces.
The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P 6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by smooth or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface when renovate. Verify compatibility between old paint and new one. Perform a test on the area 1 m<sup>2</sup>.
THINNER S 6005
Mix properly before use, thin as needed.
Total dry film has to be 80 µm. Drying time of second coat would be slower.
Treat difficult places (corners, edges, welds, surface defects), when spraying at first. Paint these places by brush, then spray the whole area including treated places. Second coat applies after 24 hours, in case of spraying “wet to wet” after 15-30 minutes. GHS02 - flammable substances GHS05 - corrosive and caustic substances GHS07 - irritants GHS09 - substances hazardous to the environment
SURFACE PREPARATION
The surface has to be clean, dry and free of grease, rust and dust. Degrease by technical benzene P 6402, acetone P 6401 or hot water with detergent. Salt residue rinse with water. Defective or poorly adhering impurities remove by smooth or scraping, thoroughly remove rust (metal brush, grindstone, rust remover). Rust remover rinse by water.
Previously painted surfaces clean, degrease and remove all poorly adhering old coats to the solid surface when renovate. Verify compatibility between old paint and new one. Perform a test on the area 1 m<sup>2</sup>.
THINNER S 6005
RECOMMENDED APPLICATION
Mix properly before use, thin as needed.
Total dry film has to be 80 µm. Drying time of second coat would be slower.
Treat difficult places (corners, edges, welds, surface defects), when spraying at first. Paint these places by brush, then spray the whole area including treated places. Second coat applies after 24 hours, in case of spraying “wet to wet” after 15-30 minutes.
Safety notice
GHS02 - flammable substances GHS05 - corrosive and caustic substances GHS07 - irritants GHS09 - substances hazardous to the environment Signal word: Danger
Content of hazardous substances
Uhlovodíky, C9, aromatické, isobutyl-alkohol
| EUH211 | Attention! Hazardous respirable droplets may form when sprayed. Do not inhale aerosols or mist. |
|---|---|
| H226 | Flammable liquid and vapors. |
| H315 | It irritates the skin. |
| H318 | Causes serious eye damage. |
| H335 | May cause respiratory irritation. |
| H411 | Toxic to aquatic organisms, with long-term effects. |
| P101 | If medical attention is needed, have the product packaging or label on hand. |
| P102 | Keep out of reach of children. |
| P210 | Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. No smoking. |
| P270 | Při používání tohoto výrobku nejezte, nepijte ani nekuřte. |
| P271 | Používejte pouze venku nebo v dobře větraných prostorách. |
| P273 | Avoid release to the environment. |
| P280 | Wear protective gloves/protective clothing/safety glasses/face shield. |
| P305+P351+P338 | IF IN EYES: Rinse carefully with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing. |
| P312 | If you feel unwell, call the TOXICOLOGICAL INFORMATION CENTER/doctor/ tel. 224 919 293 or 224 915 402 (24 hours a day) |
| P501 | Remove the contents/packaging according to the instructions on the product. |
Parameters
| Producer | Skupina BARVY A LAKY |
|---|---|
| Brand | Hostagrund |
| Product list |