BETEX 2in1 FOR CONCRETE S2131

The product is determined for semi-matt decorative coatings of mineral surfaces and concrete, e.g. floors of cellars, garages, terraces, balconies, walls and columns, for both interior and exterior. The product is highly resistant against weather conditions, mechanical wearing and has a short-term resistance against some solvents as diesel, engine oil, sulphuric acid. It is not suitable for coating of glazed or monolithic concrete surfaces. It meets the slip resistance requirements.

BENEFITS

• long-term weather resistance
• moisture and chemical resistance
• meets the slip requirements (dry surface)

SURFACE PREPARATION

Concrete or masonry substrate must be dry, compact, clean, well-matured (usually 4-6 weeks) and insulated against ground (bottom) moisture. The surface must be free of dust, grease, remains of petroleum products and asphalt and other impurities. It is ideal to suck a dust with powerful vacuum cleaner. When a water jet cleaning is necessary, it is recommended to leave the substrate to dry thoroughly.

Thinner: BALTECH S6005

Spreading capacity: 7 - 8 m²/kg per one layer

WORKFLOW

Stir paint thoroughly throughout the whole volume and dilute it with thinner BALTECH S6005 in a weight ratio 1 part of BETEX S2131 and 1 part of thinner BALTECH S6005. Apply diluted paint (usually by a roller) on the prepared surface.

Apply the paint at the dried penetrating primer (about 24 hours).  The finish coat is recommended to apply after thorough drying of the previous coat. It is not recommended to dilute the paint for finish coat.  Optimal total dry film thickness is 80 µm.

SHADES

0100 white, 0440 blue, 0510 green, 0840 russet

GHS02 - flammable substances GHS05 - corrosive and caustic substances GHS07 - irritants GHS08 - substances hazardous to health

Signal word: Danger

Obsahuje Xylen (směs), butan-1-ol.